EDIT:
it turns out that I'm and idiot - what happened is that I accidentally unhooked the +12v and +5v molex pins extender thus cutting power to the steppers themselves. After reattaching it, the steppers sprang into life.
it turns out that I'm and idiot - what happened is that I accidentally unhooked the +12v and +5v molex pins extender thus cutting power to the steppers themselves. After reattaching it, the steppers sprang into life.
Quote
uncle_bob
To put it simply, none of your motors run no matter how you try to run them. Is that correct?
Does your hot end / heated bed heat up properly?
Is this a printer that was working up and working?
Assuming the hot end and heated bed work, none of the motors work at all, and the printer once worded - first check would be to make sure the firmware reflects the hardware. Put another way - does configuration.h have all the proper stuff for your board.