The Mircochip parts are dual channel drivers. They need normal / already there bypassing. They work fine with a 10 ohm resistor (or no resistor at all) going to the gate. No other extra parts / resistors / capacitors .. nada. Eight pin package to fit in easy on the layout.
The gotcha with any form of open collector / open drain is normally the gate going high rather than the gate going low end of the process. You can't run a 10 ohm pull up resistor to the +12V rail and have a 20ma device pulling it down.
The gotcha with any form of open collector / open drain is normally the gate going high rather than the gate going low end of the process. You can't run a 10 ohm pull up resistor to the +12V rail and have a 20ma device pulling it down.
