I've looked into the RAMBo possibility and it's becoming more feasible to me, it's kind of confusing with all the different configurations. I'd wire the two Y motors in parallel, which I'll check when I take the bottom panel off because I think that's how they're wired anyway.
I just have 3 more questions:
-I have a Duo so that means I have 2 extruders, if I switch to Ramps does that mean I can only use one or can the board accommodate 2 extruders and I just haven't seen one wired like that?
-If I went with Marlin on board, that would work with KISSlicer correct?
-And I would need a separate printer interface to use with KISSlicer like Pronterface, correct?
Sorry for all the questions, but you've been a huge help. Thanks, uncle_bob
I just have 3 more questions:
-I have a Duo so that means I have 2 extruders, if I switch to Ramps does that mean I can only use one or can the board accommodate 2 extruders and I just haven't seen one wired like that?
-If I went with Marlin on board, that would work with KISSlicer correct?
-And I would need a separate printer interface to use with KISSlicer like Pronterface, correct?
Sorry for all the questions, but you've been a huge help. Thanks, uncle_bob