Thank you for all the info. I think I'll go with the TMC260 chip TOS-100 controller, I contacted the shop say they are very good, diagnostic software is cool too.
They support up to 256microsteps (the once from china does not). I can easily diagnose any problems with the diagnostic software.
I decided to get a controller for every motor. Arduino mega to drive them because I read that connecting Step, DIR pins is not recommended. So I need a bunch of pins to drive them, plus sensors, LCD etc.
I'm looking for smooth low speed, very little vibration. TOS-100 controller can drive up to 1.7A can anyone recommend quality motors?
I've seen [www.ebay.de]
I need 6 steppers. So very expensive ones are not an option.
They support up to 256microsteps (the once from china does not). I can easily diagnose any problems with the diagnostic software.
I decided to get a controller for every motor. Arduino mega to drive them because I read that connecting Step, DIR pins is not recommended. So I need a bunch of pins to drive them, plus sensors, LCD etc.
I'm looking for smooth low speed, very little vibration. TOS-100 controller can drive up to 1.7A can anyone recommend quality motors?
I've seen [www.ebay.de]
I need 6 steppers. So very expensive ones are not an option.