Hi James,
I think that is the issue. Thanks a lot for your valuable suggestion!
Will change and see what it does.
btw what happened is
The config file has these listed
// Sanguinololu 1.2 and above = 62
// Gen 7 @ 16MHZ only= 7
First I had the selected "62". I tried to upload using Arduino 1.0.3 and it wasn't uploading. I tried a lot of things, like uploading bootloader again, et al and one of them was changing motherboard setting to "7". Finally found the soln was using Arduino 23 but I haven't changed the motherboard setting back to "62".
In "62" the X_step pin is 15, while in "7" is pin 15 is PS_ON_PIN
I think that is the issue. Thanks a lot for your valuable suggestion!
Will change and see what it does.
btw what happened is
The config file has these listed
// Sanguinololu 1.2 and above = 62
// Gen 7 @ 16MHZ only= 7
First I had the selected "62". I tried to upload using Arduino 1.0.3 and it wasn't uploading. I tried a lot of things, like uploading bootloader again, et al and one of them was changing motherboard setting to "7". Finally found the soln was using Arduino 23 but I haven't changed the motherboard setting back to "62".
In "62" the X_step pin is 15, while in "7" is pin 15 is PS_ON_PIN
