Quantcast
Channel: Reprap Forum - Controllers
Viewing all articles
Browse latest Browse all 10211

Re: brushless motor for milling spindle on servo port

$
0
0
You need an RC electronic brushless speed controller. This has a 3 pin input which connects to where you would plug a servo. There are 3 output wires which go to the motor. Another 2 wires go to the power source. The speed of the motor is proportional to the pulse width input.If the motor runs the wrong way, reverse 2 of the wires. The ESC come in various current ratings to suit your motor.

I am going to use the same idea for light milling. Not sure what software is required to create milling or drilling or plotting commands.

Viewing all articles
Browse latest Browse all 10211

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>