Hello,
Excuse Me if someone has already put up a thread about this.
I am using Arduino MEGA 2560 + RAMPS 1.4
While trying to test my Endstops, i dont know how, but suddenly by z axis stepper driver blew off on my RAMPS 1.4
Now, while i try to connect the Arduino board ( without Ramps 1.4 on top of it ) to my laptop, the laptop does not detect the Arduino.
I have even tried to check in the Device Manager. It does not show the Arduino there.
Also, Arduino is getting heated up, as soon as i connect it to my laptop.
But, The little LED glows when connected.
Further, when i try to run an example from the Arduino software, the software cannot upload it. It say, COM1 not found.
Is my Arduino working or dead ?
Is there a way, i can find out.
Someone please help me.
Excuse Me if someone has already put up a thread about this.
I am using Arduino MEGA 2560 + RAMPS 1.4
While trying to test my Endstops, i dont know how, but suddenly by z axis stepper driver blew off on my RAMPS 1.4
Now, while i try to connect the Arduino board ( without Ramps 1.4 on top of it ) to my laptop, the laptop does not detect the Arduino.
I have even tried to check in the Device Manager. It does not show the Arduino there.
Also, Arduino is getting heated up, as soon as i connect it to my laptop.
But, The little LED glows when connected.
Further, when i try to run an example from the Arduino software, the software cannot upload it. It say, COM1 not found.
Is my Arduino working or dead ?
Is there a way, i can find out.
Someone please help me.
