Quantcast
Channel: Reprap Forum - Controllers
Viewing all articles
Browse latest Browse all 10211

Re: X axis Stepper only moves one way (Melzi v2 board) - help request

$
0
0
Ok, so that is telling you the firmware thinks the endstop is always triggered. If the switch is good, then the problem is in the wiring or the config.

It's also possible the endstop input on the CPU has been zapped.

Viewing all articles
Browse latest Browse all 10211

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>