Edit - I'm slightly confused about the steppers now I've been researching them more.
This is aside from the issue with the board, which I believe is faulty.
The ones I have are:
17HS3404N - which are shown as 12v 0.4a phase resistance 30 ohms
The ones my friends both have on their machines are:
YH42BYGH47-401A - which I've seen on some sites saying 2.8v and other sites saying 12v, but 1.68a and 1.65 ohms phase resistance.
So are the ones I've got unsuitable? They appear to be higher impedance than the steppers on both my friends' machines, but I'm unsure about the voltage since I've seen their models described as both 2.8v and 12v depending where I look.
I can order the right steppers if the ones I've got are no use, but I don't want to waste money doing that if the 12v ones I've got should be ok still with this controller board?
Many thanks!
This is aside from the issue with the board, which I believe is faulty.
The ones I have are:
17HS3404N - which are shown as 12v 0.4a phase resistance 30 ohms
The ones my friends both have on their machines are:
YH42BYGH47-401A - which I've seen on some sites saying 2.8v and other sites saying 12v, but 1.68a and 1.65 ohms phase resistance.
So are the ones I've got unsuitable? They appear to be higher impedance than the steppers on both my friends' machines, but I'm unsure about the voltage since I've seen their models described as both 2.8v and 12v depending where I look.
I can order the right steppers if the ones I've got are no use, but I don't want to waste money doing that if the 12v ones I've got should be ok still with this controller board?
Many thanks!