Hy everyone! Thanks forward for helping me.
Here is my video, what i uploaded: [youtu.be]
As it shown on this video, in the same circumstances (same wiriring, same volt adjustments, same driver) my "Z" axis is working, but the "y" (and also the "x") won't. I changed the motors, but it's not the fault of the steppers, because on the "Z" wiriring both of them works perfectly. I also changed the "y" stepper motor driver (Pololou A4988) (i had some "leftover" from my order), but it won't change nothing.
What can cause this problem? Anyone saw something similar before?
Thank you so much forward for all again!
David
Here is my video, what i uploaded: [youtu.be]
As it shown on this video, in the same circumstances (same wiriring, same volt adjustments, same driver) my "Z" axis is working, but the "y" (and also the "x") won't. I changed the motors, but it's not the fault of the steppers, because on the "Z" wiriring both of them works perfectly. I also changed the "y" stepper motor driver (Pololou A4988) (i had some "leftover" from my order), but it won't change nothing.
What can cause this problem? Anyone saw something similar before?
Thank you so much forward for all again!
David