It works!!!
I had my endstops wired into the RAMPS board incorrectly. I had pin 4 plugged into Ground (-), and pin 1 plugged into Signal (S). If my endstops were wired Normally Closed the connection would have been fine. However, my endstops are wired "Normally Open". So I needed to plug pin 3 (or 2 since they are actually connected on the little endstop board) into Signal (S) and pin 4 into Ground (-).
My printer printed its first part last night! Woot!!! More tweaking to go but I'm so happy it printed something!!! (Its a frog) (:D :D
I had my endstops wired into the RAMPS board incorrectly. I had pin 4 plugged into Ground (-), and pin 1 plugged into Signal (S). If my endstops were wired Normally Closed the connection would have been fine. However, my endstops are wired "Normally Open". So I needed to plug pin 3 (or 2 since they are actually connected on the little endstop board) into Signal (S) and pin 4 into Ground (-).
My printer printed its first part last night! Woot!!! More tweaking to go but I'm so happy it printed something!!! (Its a frog) (:D :D