hi I'm not sure what you mean with the resistor being between the thermos tor and the hot end. I've connected them both to the RAMPS 1.4 board directly haven't soldered on any resistor, so unless the board comes with it pre soldered l wouldn't know.
As for glues I haven't used any anything has been soldered on, I don't know about the hotend heater it came attached to its cables.
And I have set my voltage supply to 13 Volts (I used to have it on 12 volts chwnyiy voltage had no effect on this phenomenon)
As for glues I haven't used any anything has been soldered on, I don't know about the hotend heater it came attached to its cables.
And I have set my voltage supply to 13 Volts (I used to have it on 12 volts chwnyiy voltage had no effect on this phenomenon)
