Hi There,
I'm working on wiring an OG X-box 360 PSU for use with my printrbot GO and am not 100% sure what to do with the +5VSB and Power Enable leads. One article I found said you could just twist these together or wire them with a switch for standby, which sounds like what you did. But when you say the 5V supplies 1A, what do you mean? Does it supply a low current when on standby? If so, what is it powering? You'll have to forgive my noob questions, I'm electrically challenged one might say. :)
_john
ei8htohms.tinyparts.net
I'm working on wiring an OG X-box 360 PSU for use with my printrbot GO and am not 100% sure what to do with the +5VSB and Power Enable leads. One article I found said you could just twist these together or wire them with a switch for standby, which sounds like what you did. But when you say the 5V supplies 1A, what do you mean? Does it supply a low current when on standby? If so, what is it powering? You'll have to forgive my noob questions, I'm electrically challenged one might say. :)
_john
ei8htohms.tinyparts.net