Hehe..no worries..is part of the painful process...:)
Layer height is controlled in the Slicer.
If you have Repetier it is the second menu, under the button of "configure". Then Slicer pops up and you can see it in the first menu where it says "Print settings".
If you have Pronterface or any other you will have to find the Slicer, open it and change the configuration...
Happy printing!
Layer height is controlled in the Slicer.
If you have Repetier it is the second menu, under the button of "configure". Then Slicer pops up and you can see it in the first menu where it says "Print settings".
If you have Pronterface or any other you will have to find the Slicer, open it and change the configuration...
Happy printing!