Dear Reprappers,
See attached pic. Picture shows the back of the Ramps 1.4 Shield.
The Heater cables must have touched as I was experimenting.
Question: Can I use a 20 gauge wire and bridge the highlighted connections?
My first attempt was to add solder to bridge the burnt gap on the copper film, but this results with the Printer Heater unresponsive, heater continues to hit 240C and does not respond to functions within Pronterface
Can anyone with some experience suggest a fix? Easy to buy a new ramps 1.4 board but why if I can fix it smiling smiley
Please advise,
Janski
See attached pic. Picture shows the back of the Ramps 1.4 Shield.
The Heater cables must have touched as I was experimenting.
Question: Can I use a 20 gauge wire and bridge the highlighted connections?
My first attempt was to add solder to bridge the burnt gap on the copper film, but this results with the Printer Heater unresponsive, heater continues to hit 240C and does not respond to functions within Pronterface
Can anyone with some experience suggest a fix? Easy to buy a new ramps 1.4 board but why if I can fix it smiling smiley
Please advise,
Janski