Thanks guys
Sorry, when I mentioned acetone I meant just using that to wipe the bed clean, not using ABS juice. I should have been more clear.
Not sure re the label, it was a gallon I bought when rebuilding my boat but there's no label on it now.
I've tried direct on heated glass but that won't stick either. Going to get some hairspray at lunchtine!
I nearly got the new extruder assembly working last night but the mounting of the stepper motor does not seem to allow the pinion to mesh with the main gear, so I need to get the dremel on it to modify the fit. It's a bit of a mess though. I'm not certain if it will work correctly but I'll try again tonight.
I'll try to buy some blue tape. Does it go by another name at all that specifies more what it is?
Sorry, when I mentioned acetone I meant just using that to wipe the bed clean, not using ABS juice. I should have been more clear.
Not sure re the label, it was a gallon I bought when rebuilding my boat but there's no label on it now.
I've tried direct on heated glass but that won't stick either. Going to get some hairspray at lunchtine!
I nearly got the new extruder assembly working last night but the mounting of the stepper motor does not seem to allow the pinion to mesh with the main gear, so I need to get the dremel on it to modify the fit. It's a bit of a mess though. I'm not certain if it will work correctly but I'll try again tonight.
I'll try to buy some blue tape. Does it go by another name at all that specifies more what it is?