Quantcast
Channel: Reprap Forum - Controllers
Viewing all articles
Browse latest Browse all 10211

Re: Unusual stepper ratings - vref settings for new Melzi

$
0
0
Thanks for the suggestions - I've got an infrared temperature gun thing and I know the bed heats around 15-20C lower than it states on screen. It's harder to gauge with the extruder.
I printed this last night and I'm so pleased to finally get something that worked (I got the blue tape!), but as you can see the infill is really bad.

I wasn't sure why but when it finished I could see it was no longer extruding correctly. I had it at 200 degrees, and at times when I push the filament it came out freely but then seemed to jam. I've got no idea why as the extruder gets a good grip on it. Not sure if I've got dodgy settings that could be causing the hobbed bolt to get clogged up if it's trying to go too quickly. I've got it set at 13mm extrude, at 150mm/min, with 3mm PLA, 0.5mm tip, and 0.4mm layers.





Viewing all articles
Browse latest Browse all 10211

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>