Hello to all
I have a MakerFarm prusa I3 8" and collecting information on building a new printer with larger dimensions and options as far as hotends. My Makerfarm printer has the ramps 1.4 board on it and I like the ease of use and marlin firmware. I am seeing people talk about different hotends and higher temps for other filament types, and was wandering what electronics they are using, I know I have tried to set my temp higher than 230 in my slicing program and then it errors out at the printer trying to heat up, so I guess it is a limitation setting in the marlin firmware for safety. I have done some minor searching on the web, but probably just not entering in the right keywords to get the correct answer.
Thanx in advance for any information the group can share
Natas70
I have a MakerFarm prusa I3 8" and collecting information on building a new printer with larger dimensions and options as far as hotends. My Makerfarm printer has the ramps 1.4 board on it and I like the ease of use and marlin firmware. I am seeing people talk about different hotends and higher temps for other filament types, and was wandering what electronics they are using, I know I have tried to set my temp higher than 230 in my slicing program and then it errors out at the printer trying to heat up, so I guess it is a limitation setting in the marlin firmware for safety. I have done some minor searching on the web, but probably just not entering in the right keywords to get the correct answer.
Thanx in advance for any information the group can share
Natas70