I am looking to upgrade the heatbed/printing bed on this printer. It has under 1 resistance which is a headache to use.
I have been searching online for any information I can find about the Heatbed MK2A-ALU Heatbed or one similar.
The only information I can find is that people have issues with aluminum heat beds warping after a few uses. These posts
do not specify if it was the 3mm thick version.
Any one use or have any recommendations?
I have been searching online for any information I can find about the Heatbed MK2A-ALU Heatbed or one similar.
The only information I can find is that people have issues with aluminum heat beds warping after a few uses. These posts
do not specify if it was the 3mm thick version.
Any one use or have any recommendations?