All sounds nice, the only thing that I would demand is more Mid-power outputs:
2 mid power output (for fans, LEDs, …)
Only 2 is not enough for me. I already use 5 with a breakout board from Gadgets3D, however, it would ofcourse have it's quality if the board could run around 5 different fans/LED's.
And finally, the size, but I think this has been covered in this topic before, so please, keep in mind. Keep things square, and small. Put the traces tighter together and more efficient, and maybe make it a 2-layer PCB?
Your options are very interesting, I hope it's serious :)
2 mid power output (for fans, LEDs, …)
Only 2 is not enough for me. I already use 5 with a breakout board from Gadgets3D, however, it would ofcourse have it's quality if the board could run around 5 different fans/LED's.
And finally, the size, but I think this has been covered in this topic before, so please, keep in mind. Keep things square, and small. Put the traces tighter together and more efficient, and maybe make it a 2-layer PCB?
Your options are very interesting, I hope it's serious :)