Thank you for your answer!
Yes I tuned them, but it didn't change anything :X
Here are the output for the three axis (for 1.2A motor):
X-axis: 0.367V
Y-axis:0.373V
Z-axis:0.370V
What is strange is that when I ask for a move of 10mm on the Z-axis, the motor does only approximately 90°. With a 1.25mm pitch on the nut, I should have much more than 90°. (I am using the default setting)
Any ideas? I tried to increase up to 0.5V, but there was no change :(
Yes I tuned them, but it didn't change anything :X
Here are the output for the three axis (for 1.2A motor):
X-axis: 0.367V
Y-axis:0.373V
Z-axis:0.370V
What is strange is that when I ask for a move of 10mm on the Z-axis, the motor does only approximately 90°. With a 1.25mm pitch on the nut, I should have much more than 90°. (I am using the default setting)
Any ideas? I tried to increase up to 0.5V, but there was no change :(