That is exactly what I was looking for.
From my latest research, I was unsure if i had two spots for thermistors. I thought it only had one input. I am going to try and run a test compile here at work in a bit. I should be able to shrink the firmware image to fit, as I had previously cleaned up a Marlin config on a my Mendel. I did notice that teacup has the capability to be installed on the 328.
I think that I am going to try and skip the enable for all motors. If my compile works with pins.h I will upload the settings here for reference.
From my latest research, I was unsure if i had two spots for thermistors. I thought it only had one input. I am going to try and run a test compile here at work in a bit. I should be able to shrink the firmware image to fit, as I had previously cleaned up a Marlin config on a my Mendel. I did notice that teacup has the capability to be installed on the 328.
I think that I am going to try and skip the enable for all motors. If my compile works with pins.h I will upload the settings here for reference.