Quantcast
Viewing all articles
Browse latest Browse all 10211

Re: Feedback wanted for single access GRBL shield

This is intended for GRBL which doesn't use arduino's bootloader, so changing the pins would require writing the firmware through the icsp port not something everyone can do. But maybe I should switch to solder jumpers to save space / time / cost.

Should all three ms pins of the driver go through the pulldown resistor? I notice ramps only does it to ms1

Viewing all articles
Browse latest Browse all 10211

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>