Dear Rep Rappers,
I have ran into a weird issue.
Recently Completed : Ramps 1.4 Hardron Ord Bot. Fully functioning and steep learning curve.
Thinking that I have this in the bag, I went ahead and purchased parts for the 2nd one:
After Setup and Firmware upload: motors are not working properly! AHHH!!
I checked Pots: all set correctly at 0.80v. So there is power going to the motors. 12v power supply : 12.5v supplied.
Why do they move a step at a time? and if set for 100 mm it just makes weird noise.
This grinds my gears, because I would assume the same process goes for the same build. Could it be the manufacturer of the Arduino 2560/ramps 1.4?
Please advise if you have any experience with :Skipping motors
Sincerely,
Janski
I have ran into a weird issue.
Recently Completed : Ramps 1.4 Hardron Ord Bot. Fully functioning and steep learning curve.
Thinking that I have this in the bag, I went ahead and purchased parts for the 2nd one:
After Setup and Firmware upload: motors are not working properly! AHHH!!
I checked Pots: all set correctly at 0.80v. So there is power going to the motors. 12v power supply : 12.5v supplied.
Why do they move a step at a time? and if set for 100 mm it just makes weird noise.
This grinds my gears, because I would assume the same process goes for the same build. Could it be the manufacturer of the Arduino 2560/ramps 1.4?
Please advise if you have any experience with :Skipping motors
Sincerely,
Janski