My motors are Nema 17 /1.8 deg/ 2.5 belts
How about default set steps per unit in marlin? Mine is set for 78.7402 for x and y axes. On the first build the units worked but on this particular one when i leave it at 78.7402 the motors make the noise and do not make a revolution. When i 1/2 that at set at 39.... For x and y , it starts to look more like proper revolution.
I am using the same belts and motors as i did on first build.
So do i keep on trial and error untill the movement is correct as you mention above?
How about default set steps per unit in marlin? Mine is set for 78.7402 for x and y axes. On the first build the units worked but on this particular one when i leave it at 78.7402 the motors make the noise and do not make a revolution. When i 1/2 that at set at 39.... For x and y , it starts to look more like proper revolution.
I am using the same belts and motors as i did on first build.
So do i keep on trial and error untill the movement is correct as you mention above?