Hello,
Is there any way to get current firmwares like Sprinter to run on Generation 3 Electronics/Tech Zone Remix ?
I found that Sprinter supports Techzone Monotronics (whichs is basically the same, but on a single board without rs485 connected external extruder controller).
And I also read here that there is a Gen3+ daughter board that replaces the external extruder controller from Original Generation 3 Electronics enabling it to run current Firmwares, but it won't fit onto the generation 3 techzone remix main board.
So is there any way to reuse gen 3 techzone remix with current firmwares?
Is there any way to get current firmwares like Sprinter to run on Generation 3 Electronics/Tech Zone Remix ?
I found that Sprinter supports Techzone Monotronics (whichs is basically the same, but on a single board without rs485 connected external extruder controller).
And I also read here that there is a Gen3+ daughter board that replaces the external extruder controller from Original Generation 3 Electronics enabling it to run current Firmwares, but it won't fit onto the generation 3 techzone remix main board.
So is there any way to reuse gen 3 techzone remix with current firmwares?
