Ah, okay, I see. So if STP55NF06L is the MOSFET on my board (it's an Ultimachine board, I'll check the MOSFET on it when I get home), then by far the easiest solution would be to:
Is that right? If so, that's pretty darn simple. Basically I'm using all of the stock onboard components, and just bypassing the 11A fuse, and adding a thick gauge wire in addition to the thin traces.
- Solder wire from + input terminal to + output terminal
- Solder wire going from - input terminal to onboard MOSFET source
- Solder wire going from MOSFET drain to - output terminal
Is that right? If so, that's pretty darn simple. Basically I'm using all of the stock onboard components, and just bypassing the 11A fuse, and adding a thick gauge wire in addition to the thin traces.