Thanks for the support powool,
I haven't had much time to test this weekend but did manage to get the stepper turning...faulty drivers. Probably because I originally connected them the wrong way round. It's always the simple things I guess.
I have some dvr8825 stepper drivers that I want to try with this setup, they're supposed to be a direct replacement for the A4988 and A4982, what's the best way to make sure they're using 1/32 microsteps? Is there any configuration needed in the code? I see the A4988MicroStep.h in the microstep folder, there's a switch in there with the different pin configs do I just need to add one to the end for 1/32 microsteps with a different pin configuration?
Thanks in advance!
Riz
I haven't had much time to test this weekend but did manage to get the stepper turning...faulty drivers. Probably because I originally connected them the wrong way round. It's always the simple things I guess.
I have some dvr8825 stepper drivers that I want to try with this setup, they're supposed to be a direct replacement for the A4988 and A4982, what's the best way to make sure they're using 1/32 microsteps? Is there any configuration needed in the code? I see the A4988MicroStep.h in the microstep folder, there's a switch in there with the different pin configs do I just need to add one to the end for 1/32 microsteps with a different pin configuration?
Thanks in advance!
Riz