Hey Reprappers,
While making my 2nd Ord bot, using Ramps 1.4, I have encountered an issue:
"The printer seems to freeze and lose connection to COM3 about 43 seconds before print ends."
Has anyone encountered this type of an issue? I switched USB cables and USB ports. Thought perhaps the connection on the USB port on ramps 1.4 was broken. Not sure through.
Please advise :)
While making my 2nd Ord bot, using Ramps 1.4, I have encountered an issue:
"The printer seems to freeze and lose connection to COM3 about 43 seconds before print ends."
Has anyone encountered this type of an issue? I switched USB cables and USB ports. Thought perhaps the connection on the USB port on ramps 1.4 was broken. Not sure through.
Please advise :)