Hello! I have been round and round with this heat bed and can not seem to figure it out. I have a MK@a 12v bed connected to ramps 1.4. The thermistor is working I have tested it. When i try the M303 auto temp config, the bed turns on for a few sec and then turns off. The big yellow fuse gets very hot so hot can not touch. I have tested ohm and am getting around 0.9 to 1.0.. I have soldered and unsoldered and soldered again and a gin, trying to make sure that I have a good solid joint. If someone can try to lead me the right way, that would be great.
Thanks Demon
Thanks Demon
