I built a prusa about a year ago and it has worked flawlessly since. I used a 12v p/s and the Rambo 1.1b board and marlin firmware with pronterface.
I am now trying to build another printer using a 24v p/s and a Rambo 1.2e. I loaded the exact same version of marlin firmware and started by testing the motors but I am getting "printer stopped due to errors. Fix the error and use m999 to. Restart..."
At this point, the extruded and heat bed are not connected. Just the x, y, and z.motors are connected.
The power supply type is set to 1, and the board to 301 I didn't see any configuration that needed to change from the 12v. Rambo 1.1b printer.
Can anyone give me an idea of where to start troubleshooting?
Charlie
I am now trying to build another printer using a 24v p/s and a Rambo 1.2e. I loaded the exact same version of marlin firmware and started by testing the motors but I am getting "printer stopped due to errors. Fix the error and use m999 to. Restart..."
At this point, the extruded and heat bed are not connected. Just the x, y, and z.motors are connected.
The power supply type is set to 1, and the board to 301 I didn't see any configuration that needed to change from the 12v. Rambo 1.1b printer.
Can anyone give me an idea of where to start troubleshooting?
Charlie