Hi
I am working on a Rostock 3d printer and I had a question about the heat bed. I am looking to use a 240mm round heat bed from Ultibots, but it is 24v instead of 12v, what would it take to run this heat bed on the ramps 1.4?
Here is a link to the heater for the heat bed
24v kapton heater
Thanks
Tanner
I am working on a Rostock 3d printer and I had a question about the heat bed. I am looking to use a 240mm round heat bed from Ultibots, but it is 24v instead of 12v, what would it take to run this heat bed on the ramps 1.4?
Here is a link to the heater for the heat bed
24v kapton heater
Thanks
Tanner