Hi!
My printer has had a vacation for the last few weeks, everything was working fine the last time i used it. (except for a broken hotend resistor)
but when i started it up and ran it from pronterface, as usual, every axis is inverted..(X,Y,Z,E.. all of them)
thinking i might have updated the firmware the last thing i did before it got its vacation i tried to re-upload marlin 1.0 RC2. but now i get avrdude error, as if arduino cant find my Gen6 board..
im running out of ways to troubleshoot..
what might be a part of the problem is that i changed the hotend resistor before powering up, but even reversing these wires would'nt make this strange across the board inverting of all pin-outputs.. i did try to re-wire these cables but it made no difference.
i've got a fan hooked up at the power inlet to the board, and this is not inverted, so it is not the power supply. it has to be something on the board.
Gen6 board
Marlin v1.0.0 RC2
Pronterface
My printer has had a vacation for the last few weeks, everything was working fine the last time i used it. (except for a broken hotend resistor)
but when i started it up and ran it from pronterface, as usual, every axis is inverted..(X,Y,Z,E.. all of them)
thinking i might have updated the firmware the last thing i did before it got its vacation i tried to re-upload marlin 1.0 RC2. but now i get avrdude error, as if arduino cant find my Gen6 board..
im running out of ways to troubleshoot..
what might be a part of the problem is that i changed the hotend resistor before powering up, but even reversing these wires would'nt make this strange across the board inverting of all pin-outputs.. i did try to re-wire these cables but it made no difference.
i've got a fan hooked up at the power inlet to the board, and this is not inverted, so it is not the power supply. it has to be something on the board.
Gen6 board
Marlin v1.0.0 RC2
Pronterface