... the galvo-head is OK, but the mirrors are designed for CO2-laser wavelength -- which laser do you have?
You'll need a high-speed analogue driver with up to 16Bit resoultion, what's not possible with an Arduino ... I'm using a dedicated driver for ILDA lasershows, but you can find proper electronics for this scanners at the manufacturers site too.
My PC-software is BeamConstruct with a self-programmed driver (here you'll need a programming license for 500€) ... check, if you can find a driver already installed in BeamConstruct, this would be the best way ...
You'll need a high-speed analogue driver with up to 16Bit resoultion, what's not possible with an Arduino ... I'm using a dedicated driver for ILDA lasershows, but you can find proper electronics for this scanners at the manufacturers site too.
My PC-software is BeamConstruct with a self-programmed driver (here you'll need a programming license for 500€) ... check, if you can find a driver already installed in BeamConstruct, this would be the best way ...