Bottom line, i see choices as:
*without introducing a junction means hard clamping, hard/impossible/not woth it, imo
*introduce a series junction, means that changes resistor divider behavior, changes thermistor tables and math, and NOT in a good way: makes them less reliable and etc, makes calibration mandatory, and this is an aspect that is already poor about reprap. Pullup should of been 560ohms not 4k7, thats the sort of change this area needs, but extra junction i dont like. I am more conservative perhaps but this is so you see where im coming from, and why. Thermistor part is weak, too much to explain newcomers hard to take in and i did it quite nr of time right on this forum. If it gets any worse wont help reprap cause at all. And risk further aggravation for many, just for a eventuality mishap, i dont think its worth it.
Well this is just me and my opinion ofc.
This time im really gone :)
*without introducing a junction means hard clamping, hard/impossible/not woth it, imo
*introduce a series junction, means that changes resistor divider behavior, changes thermistor tables and math, and NOT in a good way: makes them less reliable and etc, makes calibration mandatory, and this is an aspect that is already poor about reprap. Pullup should of been 560ohms not 4k7, thats the sort of change this area needs, but extra junction i dont like. I am more conservative perhaps but this is so you see where im coming from, and why. Thermistor part is weak, too much to explain newcomers hard to take in and i did it quite nr of time right on this forum. If it gets any worse wont help reprap cause at all. And risk further aggravation for many, just for a eventuality mishap, i dont think its worth it.
Well this is just me and my opinion ofc.
This time im really gone :)