Mine says its made in italy....... yahhhh. The rule is you do get what you pay for. My arduino has been flawless. It has been working its butt off on my printer and has not shown any signs of problems. The ramps 1.4 I bought has two short comings, 16v caps and mosfets that are not really up to high spec. I ordered mosfets for the board just in case I have to swap them out, however I can say even the original ones have not been too bad, they are not getting ungodly hot either. As for the caps the 16v caps are not up to the task of runing a 24v+ system, however they are close enough for my 12v psu. I have more amperage than I know what to do with so its fine in my book.
↧