Hi
I'm having some trouble getting the end stops on my teensyly board functioning properly.
when I type M119 I only get the X and Z reading back correctly. Y won't return a high value at all.
x end stop only returns a value when it is plugged into the E port . z seems to work fine plugged in z port
I've checked through the sprinter firmware and it appears to be set up correctly. I'm using board 8 as specified in the geeetech teensylu wiki
I believe it may be the board, what are some steps to determine what's happening here?
thanks
David
I'm having some trouble getting the end stops on my teensyly board functioning properly.
when I type M119 I only get the X and Z reading back correctly. Y won't return a high value at all.
x end stop only returns a value when it is plugged into the E port . z seems to work fine plugged in z port
I've checked through the sprinter firmware and it appears to be set up correctly. I'm using board 8 as specified in the geeetech teensylu wiki
I believe it may be the board, what are some steps to determine what's happening here?
thanks
David