Dust,
I appreciate your timely response but I need more detailed instructions for changing the pin designations. I tried to follow your instructions but could not get anywhere. Sorry!
When I open Arduino, I then do a File -> Open -> pins.h.
At this point I can either double click on pins.h file and pull up the Marlin screen where I don't know where to go, or I can right click the pins.h file to pull up what looks like a word document, make the pins swap between Z and E4, save this, upload the file to my printer and then nothing happens again. I'm obviously doing something wrong. Can you please walk me through the key strokes.
Regards,
Gonetotx
I appreciate your timely response but I need more detailed instructions for changing the pin designations. I tried to follow your instructions but could not get anywhere. Sorry!
When I open Arduino, I then do a File -> Open -> pins.h.
At this point I can either double click on pins.h file and pull up the Marlin screen where I don't know where to go, or I can right click the pins.h file to pull up what looks like a word document, make the pins swap between Z and E4, save this, upload the file to my printer and then nothing happens again. I'm obviously doing something wrong. Can you please walk me through the key strokes.
Regards,
Gonetotx
