Hello Everyone,
I am using a RUMBA board for my 3D printer and have uploaded Marlin Firmware to run it. I am using repetier host and pronterface 3d printing softwares to run my printer.
The marlin firmware software runs fine and connects the board to the softwares. I am able to jog my X, Y and Z axis as well. The extruder motor, fans and the heater also works.
The Extruder I am using is a Single head extruder ready to print from makers geek. below is a link to that.
[www.makergeeks.com]
This extruder has a k-type thermocouple to it.
I am not able to understand how to connect the K-type thermocouple to the RUMBA Board?
My Extruder axis, heater, fans and the motors run completely fine but I am not able to connect the thermocouple and also could not get any information about it.
Can anybody please help me with this issue, it will be a great help.
Thank you
Regards,
I am using a RUMBA board for my 3D printer and have uploaded Marlin Firmware to run it. I am using repetier host and pronterface 3d printing softwares to run my printer.
The marlin firmware software runs fine and connects the board to the softwares. I am able to jog my X, Y and Z axis as well. The extruder motor, fans and the heater also works.
The Extruder I am using is a Single head extruder ready to print from makers geek. below is a link to that.
[www.makergeeks.com]
This extruder has a k-type thermocouple to it.
I am not able to understand how to connect the K-type thermocouple to the RUMBA Board?
My Extruder axis, heater, fans and the motors run completely fine but I am not able to connect the thermocouple and also could not get any information about it.
Can anybody please help me with this issue, it will be a great help.
Thank you
Regards,