Quantcast
Channel: Reprap Forum - Controllers
Viewing all articles
Browse latest Browse all 10211

Re: A4988 board..GUYS KINDLY HELP ME

$
0
0
Quote
arun
I want to operate motor of 2v and 0.45amps
How did you come up with those numbers? Are they from the spec sheet from the steppers? If so, the voltage given there is just a computed value based on the resistance and current requirements. It doesn't really have any useful meaning with regards to operating the steppers as you actually usually want the voltage to run higher for more rapid current rise time.

And as NoobMan indicated, .45 amps is a pretty low current requirement. You don't say what you're using the steppers for or what size they are, but for 3D printing related tasks that's a pretty weak motor that is likely to stall or miss steps if there's anything more than minimal resistance to movement (aka load).

Viewing all articles
Browse latest Browse all 10211

Trending Articles



<script src="https://jsc.adskeeper.com/r/s/rssing.com.1596347.js" async> </script>