Hi Zachisparanoid,
I too got the same issue of melting the connector, but I used a large heatbed(10" x 10") without any relay.
Did you used the same large heatbed? If yes, do you use any relay circuit to draw more current out of PSU?
I tried connecting the #1 on J1 to PSU(ATX 450W) +12v pin on 20 pin connector as shown in image [www.makerfarm.com]
I am using 6 pin relay.
But I was not successful to heat up the bed.
Do you have any configuration/ckt for the relay to be used for large heatbed?
Regards,
Prashant.
I too got the same issue of melting the connector, but I used a large heatbed(10" x 10") without any relay.
Did you used the same large heatbed? If yes, do you use any relay circuit to draw more current out of PSU?
I tried connecting the #1 on J1 to PSU(ATX 450W) +12v pin on 20 pin connector as shown in image [www.makerfarm.com]
I am using 6 pin relay.
But I was not successful to heat up the bed.
Do you have any configuration/ckt for the relay to be used for large heatbed?
Regards,
Prashant.