hello,
last week, i made a mistake while wiring my printer with a new rumba. now 1 of the 2 12v rails is dead. i can messure some volts but there is no current flowing. so i though "just a buy a new one" so i did.
now they have sended me a rambo. not a rumba...
my first impression of a rambo: "so many variants, so little documentation"
i liked the rumba because of some upgrades i could do on my prusa i3. (mostly cooling)
what to do next ???
- send the rambo back and wait for a rumba (patience)
- use the rambo. where can i find some documents?
- fix the 12v rail. "i think i can solder a wire to both rails. at least i think the inductor area isn't needed"
what would you do
thanx
/marco
[[ it's not the same webshop i originally bought the rumba ]]
[[ first rumba was a chinese shop, but i didn't wanted to wait 2 weeks ]]
[[ 2nd was a from danmark, delivered within 1 week (!!!) (nice) ]]
last week, i made a mistake while wiring my printer with a new rumba. now 1 of the 2 12v rails is dead. i can messure some volts but there is no current flowing. so i though "just a buy a new one" so i did.
now they have sended me a rambo. not a rumba...
my first impression of a rambo: "so many variants, so little documentation"
i liked the rumba because of some upgrades i could do on my prusa i3. (mostly cooling)
what to do next ???
- send the rambo back and wait for a rumba (patience)
- use the rambo. where can i find some documents?
- fix the 12v rail. "i think i can solder a wire to both rails. at least i think the inductor area isn't needed"
what would you do
thanx
/marco
[[ it's not the same webshop i originally bought the rumba ]]
[[ first rumba was a chinese shop, but i didn't wanted to wait 2 weeks ]]
[[ 2nd was a from danmark, delivered within 1 week (!!!) (nice) ]]