End stops connected corectly. its a new printer build, didint print anything yet. all the axis goes home fine.
If the ramps would not make a proper contact, then i think the screen wouldnt show anything on the lcd all the time. Now when i plug the usb to the pc, the lcd shows all the info, i can control everything from the lcd.
No PC - no LCD :(
If the ramps would not make a proper contact, then i think the screen wouldnt show anything on the lcd all the time. Now when i plug the usb to the pc, the lcd shows all the info, i can control everything from the lcd.
No PC - no LCD :(