Alternative to Arduino Prusa i2...Launcpad tiva C?

Hi,
Here I am writing to you because I'm venturing to build a Prusa i2.
After documents, guides, tutorials, stl etc ... I'm starting to put a piece after another.

My question is, you can use a worthy alternative to Arduino?
What to do?

I hope to find someone with a good heart to give me a hand.
In particular, I find the makings of a board of Texas instrument:
EK-TM4C1294XL
We will also post a PDF of the guide so that it can be as clear as possible.
[www.ti.com]

Basically my questions are 2:
Do you think I can ride inside the ramps 1.4?
But above all ... how to connect everything you need for a Prusa i2?

Thank you in advance for your answers.