So that 11A is the holding current? What amperage will it trip at? If your polyfuse didn't trip pulling 15A then mine shouldn't at 12-ish, granted polyfuses are all the same.
But say I did wire in a 15A car fuse. It would not trip till 15A but what would get hot before it did? The copper traces on the PCB? At what amperage will other stuff on the board definitely start getting fried?
The cheap bed has LEDs so I will eventually wire it up and test it.
But say I did wire in a 15A car fuse. It would not trip till 15A but what would get hot before it did? The copper traces on the PCB? At what amperage will other stuff on the board definitely start getting fried?
The cheap bed has LEDs so I will eventually wire it up and test it.