The original sanguino with 664 only has 64kb ram, and with the 1284p it has 128kb and its also running all stuff like Display ect. when i compile a Marlin with display it actually uses about 110kb., repetier firmware uses below 80kb.
Also the AT90USB are already supported by Arduino IDE (reprap/marlin/Repetier), as the Printrboard has already the 16mhz version (AT90USB1286).
I was curisous because i installed marlin on a printrboard and was supprised how fast it will connect (instantly) and work.
Chri
Also the AT90USB are already supported by Arduino IDE (reprap/marlin/Repetier), as the Printrboard has already the 16mhz version (AT90USB1286).
I was curisous because i installed marlin on a printrboard and was supprised how fast it will connect (instantly) and work.
Chri