Hey guys,
Have a similar problem. My machine is only a couple weeks old but I have done about 100hr of prints already. Anyways I had a 16hr print fail last night and the nozzle was all goo-d up this morning. Took it all apart and when I put it back together the high temp sheaths on the heater slide back and the wires touched and shorted. Is there a fuse on this circuit. I get the 12v from D10 ground to power but it stays the same when I turn on the heater? Sorry not trying to hijack the thread just similar issue.
Thanks,
Seth
Have a similar problem. My machine is only a couple weeks old but I have done about 100hr of prints already. Anyways I had a 16hr print fail last night and the nozzle was all goo-d up this morning. Took it all apart and when I put it back together the high temp sheaths on the heater slide back and the wires touched and shorted. Is there a fuse on this circuit. I get the 12v from D10 ground to power but it stays the same when I turn on the heater? Sorry not trying to hijack the thread just similar issue.
Thanks,
Seth