Hello everybody
i am new to this forum and to 3d printing
i wont to make a 3d printer based on the teensylu electronics but the problem is that where i live we don't have the AT90USB1286
i can only found the AT90USB1287
can i use the 1287 mcu instead of 1286 mcu ?? if yes should i do anything other than the instructions in the teensylu page to upload the repetier firmware ??
should i do anything related to the fuses settings (because i got confused when i read about fuses)
sorry about my bad English
hope anybody can help me
i am new to this forum and to 3d printing
i wont to make a 3d printer based on the teensylu electronics but the problem is that where i live we don't have the AT90USB1286
i can only found the AT90USB1287
can i use the 1287 mcu instead of 1286 mcu ?? if yes should i do anything other than the instructions in the teensylu page to upload the repetier firmware ??
should i do anything related to the fuses settings (because i got confused when i read about fuses)
sorry about my bad English
hope anybody can help me