Hi guys,
I'm building a scaled up version of a Lautr3k. What I want to know is if the Rambo 1.1B board can be used to power 2 heated beds and 1 extruder instead of the default 2 extruders and 1 heated bed. I have close to no knowledge regarding electronics from an electrical engineering point of view and wondering if this is possible or if I'll just damage the Rambo board or blow it's fuse if I even try. Hoping to be able to build a print area that's around 600mm x 600mm :)
I realize i would have to go and make firmware changes for it and I'm not worried about that aspect as I am a programmer.
I'm building a scaled up version of a Lautr3k. What I want to know is if the Rambo 1.1B board can be used to power 2 heated beds and 1 extruder instead of the default 2 extruders and 1 heated bed. I have close to no knowledge regarding electronics from an electrical engineering point of view and wondering if this is possible or if I'll just damage the Rambo board or blow it's fuse if I even try. Hoping to be able to build a print area that's around 600mm x 600mm :)
I realize i would have to go and make firmware changes for it and I'm not worried about that aspect as I am a programmer.