stepper driver 1.2 instead of Pololu

hello everybody

i want to make a 3d printer based on ramps or teensylu (both can use pololu as stepper drivers)

can i use stepper driver 1.2 (stepper driver 1.2) instead of polulu ?

iknow what the deferent between the two drivers an i know its pinouts but the problem is that i cant find find any allegro driver ship where i live

so i am thinking of redesign the main board (ramps or teensylu) to add the ability to connect only [step , dir , enable ] pins to the 1.2 driver instead of pololu [8x3 socket and ms jumpers] like the schematics attached

what do you think ?